How do I remove old watch straps and attach new Shot Scope straps that I have purchased?

It is important to note that only straps produced by shot scope can be attached onto a watch.

Its also important to note that placing a V3 shot tracking strap (Power-sense strap) onto a G3 will not enable performance tracking on a G3 watch.

If you would like to purchase a new strap for your V3 or G3 you can so by clicking here.

V3 Video:

To replace your Shot Scope V3 strap:

*Remove the strap, screwdriver and spare screws from the packaging.

*Use the screwdriver provided to remove the screws by unscrewing them in an anticlockwise direction.

*Pull the straps away from the screen once the screws are removed. The Shot Scope straps will now be detached from the screen.

To attach the new straps:

*Clip the buckle strap to the bottom of the screen where the Shot Scope logo is.

*Insert the screws into the screw holes and tighten in a clockwise direction. Clip the strap with the RFID label to the top of the screen, inset the screws and tighten.

*For the Performance Tracking to work the straps must be set up this way round. Remove the information label and ensure the straps are tight by giving each side a gentle pull. Your watch is now ready to play!